FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
10. CREATING PROGRAMS
619
4 Press the [C.A.P] soft key. The following G code menu is displayed
on the screen.
If soft keys different from those shown in step 2 are displayed, press
the menu return key
to display the correct soft keys.
PROGRAM O1234 N00004
G00 : POSITIONING
G01 : LINEAR IPL
G02 : CIRCULAR IPL. CW
G03 : CIRCULAR IPL. CCW
G04 : DWELL
G10 : OFFSET VALUE SETTING (0)
G20 : INCH
G21 : METRIC
G22 : STORED STROKE CHECK ON (0)
G23 : STORED STROKE CHECK OFF (0)
G25 : SPINDLE SPEED DETECT OFF
G26 : SPINDLE SPEED DETECT ON
_
EDIT
**** *** ***
14 : 26 : 15
PRGRM
G.MENU
BLOCK
5 Key in the G code corresponding to a function to be programmed.
When the positioning function is desired, for example, the G code
menu lists the function with the G code G00. So key in G00. If the
screen does not indicate a function to be programmed, press the page
key
to display the next G code menu screen. Repeat this
operation until a desired function appears. If a desired function is not
a G code, key in no data.
6 Press the soft key
[BLOCK] to display a detailed screen for a keyed in
G code. The figure below shows an example of detailed screen for
G00.
**** *** ***
PROGRAM
G00 : POSITIONING
O1234 N00000
G00 G G G X
XU
Z W (X, Z)
M
S
T
:
EDIT 14 : 32 : 57
(OPRT)
PRGRM
G.MENU
Z
U
W
BLOCK

Leave a Reply

Your email address will not be published. Required fields are marked *