FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
626
Software operaĆ
tor's panel switch
See III-11.4.13.
Tool offset value
Display of tool
offset value
See III-11.4.1.
OFFSET SETTING WORK (OPRT)
Screen transition triggered by the function key
OFFSET
SETTING
OFFSET
SETTING
OFFSET/SETTING SCREEN
Display of setĆ
ting data
See III-11.4.7
Setting of direct
input of tool offĆ
set value
See III-11.4.2.
Parameter setting
See III-11.4.7.
Setting of work
origin offset value
See III-11.4.10.
Setting sequence
number comparison
and stop
See III-11.4.8.
Setting the number of parts required
See III-11.4.9.
Displaying run time
and parts count
See III-11.4.9.
Displaying setĆ
ting time
See III-11.4.9.
Setting of tool
offset data
See III-11.4.1.
MACRO OPR (OPRT)TOOLLF
Presetting tool life counter
Clearing executing data
See III-11.4.14.
Setting macro
variables
See III-11.4.12.
Tool offset value
Display of workĆ
piece coordinate
system
See III-11.4.10
1/2
1*
To next page
Setting of direct
input of tool offĆ
set measured B
See III-11.4.3.
Setting of countĆ
er input of offset
value
See III-11.4.3.
Display of macro
variables
See III-11.4.13.
Displaying softĆ
ware operator's
panel
See III-11.4.13.
Displaying tool life
management data
See III- 11.4.14.

Leave a Reply

Your email address will not be published. Required fields are marked *