FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
629
The table below lists the data set on each screen.
Table.11. Setting screens and data on them
No. Setting screen Contents of setting Reference
item
1 Tool offset value Tool offset value
Tool nose radius compensation value
Subsec. 11.4.1
Direct input of tool offset value Subsec. 11.4.2
Direct input of tool offset value measured B Subsec. 11.4.3
Counter input of offset value Subsec. 11.4.4
Y axis offset Subsec. 11.4.6
2 Workpiece coordinate
system setting
Workpiece coordinate system shift value Subsec. 11.4.5
sys
t
em se
tti
ng
Workpiece origin offset value Subsec. 11.4.10
3 Setting data (handy) Parameter write
TV check
Punch code (EIA/ISO)
Input unit (mm/inch)
I/O channel
Automatic insert of Sequence No.
Conversion of tape format
(F15)
Subsec. 11.4.7
Sequence number comparison and stop Subsec. 11.4.8
4 Setting data (mirror
image)
Mirror image Subsec. 11.4.7
5 Setting data (timer) Parts required Subsec. 11.4.9
6 Macro variables Custom macro common variables
(#100 to #149) or (#100 to #199)
(#500 to #531) or (#500 to #599)
Subsec. 11.4.12
7 Parameter Parameter Subsec. 11.5.1
8 Pitch error Pitch error compensation data Subsec. 11.5.2
9 software operators
panel
Mode selection
Jog feed axis selection
Jog rapid traverse
Axis selection for Manual pulse
generator
Multiplication for manual pulse
generator
Jog feedrate
Feedrate override
Rapid traverse override
Optional block skip
Single block
Machine lock
Dry run
Protect key
Feed hold
Subsec. 11.4.13
10 Tool life data
(Tool life management)
Life count Subsec. 11.4.14
11 Current position dis-
play screen
Floating reference position Subsec. 11.1.7
D  s

Leave a Reply

Your email address will not be published. Required fields are marked *