FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
632
NOTE
For the two–path control, the display may not be as shown
above. In some cases, only the coordinates along the axes
on tool post 1 are displayed due to the number of axes. In
that case, press the
[ABS] soft key one more time to display
the coordinates along the axes on tool post 2.
ACTUAL POSITION O1000 N10010
X1 100.000
Z
1 200.000
C
1 300.000
Y
1 400.000
(ACTUAL SPEED)F : 0 M M /
MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
ABS
REL (OPRT
)
O2000 N20010
X
2 500.000
Z
2 600.000
C
2 700.000
Y
2 800.000
ALL HNDL
D Display with two–path control
(14CRT/9.5 LCD)
(ACTUAL0
(ACTUAL0
(ACTUAL SPEED)F : 0MM/
MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
MEM STOP *** *** 12:34:56
HEAD1
Bits 6 and 7 of parameter 3104 can be used to select whether the displayed
values include tool offset value and tool nose radius compensation.
On the 9 CRT or the shared screen of the 14 CRT, only the coordinates
for the first to fifth axes are displayed initially whenever there are six or
more controlled axes. Pressing the
[ABS] soft key displays the
coordinates for the sixth and subsequent axes. When six or more
controlled axes are used under two–path control, the coordinates for
path 1 are displayed initially on the 9 CRT. Pressing the
[ABS] soft key
displays the coordinates for path 2. On the shared screen of the 14” CRT,
the tool post selection signal is used to select the display for path 1 or 2.
D Two–path lathe control /
9 CRT/PDP, 8.4 LCD
Explanations
D Display including
compensation values
D Displaying the sixth and
subsequent axes

Leave a Reply

Your email address will not be published. Required fields are marked *