FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
634
NOTE
For the two–path lathe control (9CRT/PDP, 8.4 LCD), the
display may not be as shown above. In some cases, only
the coordinates along the axes on tool post 1 are displayed
due to the number of axes. In that case, press the
[REL] soft
key one more time to display the coordinates along the axes
on tool post 2.
ACTUAL POSITION O1000 N10010
U
1 100.000
W
1 200.000
H1 300.000
V
1 400.000
(ACTUAL SPEED)F : 0 M M /
MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
ABS
RE
L
(OPRT
)
O2000 N20010
U
2 500.000
W
2 600.000
A2 700.000
B
2 800.000
ALL HNDL
D Display with two–path control)
(14CRT/9.5 LCD)
(RELATIVE)
(RELATIVE)
(ACTUAL SPEED)F : 0MM/
MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
MEM STOP *** *** 12:34:56
HEAD1

Leave a Reply

Your email address will not be published. Required fields are marked *