FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
637
ACTUAL POSITION O1000 N10010
(ACTUAL SPEED)F : 0MM/MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
ABS
REL (OPRT)
+
O2000 N20010
ALL HNDL
D Display with two–path control
(14CRT, 9.5 LCD)
(RELATIVE)
(ACTUAL SPEED)F : 0MM/MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
MEM STOP *** *** 12:34:56 HEAD1
U1 100.000
W1 100.000
H1 300.000
V1 400.000
(ABSOLUTE)
X1 100.000
Z1 100.000
C1 300.000
Y1 400.000
(MACHINE)
X1 100.000
Z1 100.000
C1 300.000
Y1 400.000
(DISTANCE TO GO)
X1 000.000
Z1 000.000
C1 000.000
Y1 000.000
(RELATIVE)
U2 100.000
W2 100.000
A2 300.000
B2 400.000
(ABSOLUTE)
X2 100.000
Z2 100.000
A2 300.000
B2 400.000
(MACHINE)
X2 100.000
Z2 100.000
A2 300.000
B2 400.000
(DISTANCE TO GO)
X2 000.000
Z2 000.000
A2 000.000
B2 000.000
The current positions of the tool in the following coordinate systems are
displayed at the same time:
D Current position in the relative coordinate system
(relative coordinate)
D Current position in the work coordinate system
(absolute coordinate)
D Current position in the machine coordinate system
(machine coordinate)
D Distance to go (distance to go)
The distance remaining is displayed in the MEMORY or MDI mode. The
distance the tool is yet to be moved in the current block is displayed.
The least command increment is used as the unit for values displayed in
the machine coordinate system. However, the least input increment can
be used by setting bit 0 (MCN) of parameter 3104.
On the overall position display screen, relative coordinates can be reset
to 0 or preset to specified values. The procedure is the same as that for
resetting the relative coordinates described in III–11.1.2.
On the shared screen of the 14 CRT, only the coordinates for the first to
fifth axes are displayed initially whenever there are six or more controlled
axes. Pressing the
[ALL] soft key displays the coordinates for the sixth
and subsequent axes. On the shared screen of the 14 CRT, the tool post
selection signal is used to select the display for path 1 or 2.
On the 9 CRT, relative coordinates cannot be displayed together with
absolute coordinates when there are five or more controlled axes (when
the total number of controlled axes is five or more, for two–path control).
Pressing the
[ALL] soft key toggles the display between absolute and
relative coordinates.
Explanations
D Coordinate display
D Distance to go
D Machine coordinate
system
D Resetting relative
coordinates
D Displaying the sixth and
subsequent axes
D Displaying the fifth and
subsequent axes

Leave a Reply

Your email address will not be published. Required fields are marked *