FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
640
In the case of feed per revolution and thread cutting, the actual feedrate
displayed is the feed per minute rather than feed per revolution.
In the case of movement of rotary axis, the speed is displayed in units of
deg/min but is displayed on the screen in units of input system at that time.
For example, when the rotary axis moves at 50 deg/min, the following is
displayed: 0.50 INCH/M
The program check screen also displays the actual feedrate.
D Actual feedrate display
of feed per revolution
D Actual feedrate display
of rotary axis
D Actual feedrate display
on the other screen

Leave a Reply

Your email address will not be published. Required fields are marked *