FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
645
This section describes the screens displayed by pressing function key
PROG
in MEMORY or MDI mode.The first four of the following screens
display the execution state for the program currently being executed in
MEMORY or MDI mode and the last screen displays the command values
for MDI operation in the MDI mode:
11.2.1 Program contents display screen
11.2.2 Current block display screen
11.2.3 Next block display screen
11.2.4 Program check screen
11.2.5 Program screen for MDI operation
11.2.6 Stamping the maching time
11.2.7 Displaying the B–axis operation state
Function key
PROG
can also be pressed in MEMORY mode to display the
program restart screen and scheduling screen.
See Section III–4.3 for the program restart screen.
See Section III–4.4 for the scheduling screen.
11.2
SCREENS DISPLAYED
BY FUNCTION KEY pr
(IN MEMORY MODE OR
MDI MODE)
PROG

Leave a Reply

Your email address will not be published. Required fields are marked *