FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
646
Displays the program currently being executed in MEMORY or MDI
mode.
Procedure for displaying the program contents
1 Press function key
PROG
to display a program screen.
2 Press chapter selection soft key
[PRGRM].
The cursor is positioned at the block currently being executed.
O2000 ;
N100 G50 X0 Z0. ;
N110 G91 G00 X–70. ;
N120 Z–70. ;
N130 G01 X–60 ;
N140 G41 G03 X–17.5 Z17.5 R17.5 ;
N150 G01 X–25. ;
N160 G02 X27.5 Z27.5 R27.5
N170 G01 X20. ;
N180 G02 X45. Z45. R45. ;
> _ S 0 T0000
MEM STRT *** 16:05:59
[ PRGRM ][ CHECK ][ CURRNT ][ NEXT ][ (OPRT) ]
PROGRAM O2000 N00130
On a 14–inch CRT or 9.5–inch LCD, the contents of the program are
displayed on the right half of the screen or on the entire screen (switched
each time soft key
[PRGRM] is pressed).
PROGRAM
O0006 N00000
+
O0003 ;
G65 H01 P#2001 O0 ;
G65 H01 P#2014 O0 ;
G65 H01 P#2110 O0 ;
G04 P2000 ;
G04 P2000 ;
G04 P2000 ;
G65 H01 P#2001 O50000 ;
G65 H01 P#2014 O60000 ;
G65 H01 P#2110 O30000 ;
G04 P2000 ;
G04 P2000 ;
G04 P2000 ;
G65 H02 P#2001 O#2001 R3 ;
G65 H03 P#2014 O15000 R#2014
;
G65 H04 P#2110 O3 R#2110 ;
G65 H01 P#100 O#3901 ;
G65 H01 P#101 O#3902 ;
G65 H01 P#3901 O#102 ;
G65 H01 P#3902 O#103 ;
G04 P5000 ;
G04 P5000 ;
G04 ;
G65 H01 P#100 O#4001 ;
G65 H01 P#101 O#4002 ;
/ G65 H01 P#102 O#4003 ;
G65 H01 P#103 O#4004 ;
G65 H01 P#104 O#4005 ;
G65 H01 P#105 O#4006 ;
G65 H01 P#106 O#4007 ;
G65 H01 P#107 O#4008 ;
G65 H01 P#108 O#4009 ;
MEM **** *** *** 07:12:55
O SRH SRH
SRH
REWIND
11.2.1
Program Contents
Display
Explanations
D  
9.5–inch LCD

Leave a Reply

Your email address will not be published. Required fields are marked *