FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
647
Displays the block currently being executed and modal data in the
MEMORY or MDI mode.
Procedure for displaying the current block display screen
1 Press function key
PROG
.
2 Press chapter selection soft key
[CURRNT].
The block currently being executed and modal data are displayed.
The screen displays up to 22 modal G codes and up to 11 G codes
specified in the current block.
(CURRNT) (MODAL)
G01 ·X 100.500 G18 G00 F
·F 50.000 G50.2G97
G13.1G69
G99
G21 T
G40 S
G25
G22
G80
G67 SACT 0
G54
> _ S 0 T0000
MEM STRT *** 16:05:59
[ PRGRM ][ CHECK ][ CURRNT ][ NEXT ][ (OPRT) ]
PROGRAM O2000 N00130
The current block display screen is not provided for 14–inch CRTs. Press
soft key
[PRGRM] to display the contents of the program on the right half
of the screen. The block currently being executed is indicated by the
cursor. Modal data is displayed on the left half of the screen.
The screen displays up to 18 modal G codes.
11.2.2
Current Block Display
Screen
Explanations
D 14 inch CRT screen

Leave a Reply

Your email address will not be published. Required fields are marked *