FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
650
PROGRAM CHECK O1000 N01010
(MODAL)
G00 G98 G25 G67 M
G97 G21 G22 G54 M
G69 G40 G90 G18 M
T
F 3000.000 (ACT.F)
0MM/MIN
S 1000 (ACT.S) 0RPM
>_
PRGRM
(OPRT)
CHECK NEXT
N01000 G90 X100. Z100.;
N01010 G01 X50. Z50. F2000. ;
N01020 X30. ;
N01030 X50. Z–40. ;
N01040 Z–60. ;
(RELATIVE) (ABSOLUTE) (DIST TO
GO)
U1 100.000 X1 100.000 X1
0.000
W1 200.000 Z1 200.000 Z1
0.000
H1 300.000 C1 300.000 C1
0.000
V1 400.000 Y1 400.000 Y1
0.000
PROGRAM CHECK O2000 N02010
(MODAL)
G00 G98 G25 G67 M
G97 G21 G22 G54 M
G69 G40 G90 G18 M
T
F 3000.000 (ACT.F) 0MM/MIN
S 1000 (ACT.S) 0RPM
S 0 T0000
MEM STOP *** *** 14:00:00 HEAD1
N02010 G90 X200. Z200.;
N02020 G01 X50. Z50. F3000. ;
N02030 G01 X50.. ;
N02040 Z–50. ;
N02050 X0 Z0 A0 B0 ;
(RELATIVE) (ABSOLUTE) (DIST TO GO)
U2 500.000 X2 500.000 X2 0.000
W2 600.000 Z2 600.000 Z2 0.000
A2 700.000 A2 700.000 A2 0.000
B2 800.000 B2 800.000 B2 0.000
D Display with two path control
(14CRT)
The screen displays up to four blocks (five blocks on the 14 CRT when
two–path control is being used) of the current program, starting from the
block currently being executed. The block currently being executed is
displayed in reverse video. During DNC operation, however, only three
blocks can be displayed.
The position in the workpiece coordinate system or relative coordinate
system and the remaining distance are displayed. The absolute positions
and relative positions are switched by soft keys
[ABS] and [REL].
On the 9 CRT when there are six or more controlled axes, pressing the
[ABS] soft key toggles the display between the absolute coordinates for
the first to fifth axes and those for the sixth to eighth axes. Pressing the
[REL] soft key toggles the relative coordinate display in the same way.
Up to 12 modal G codes are displayed.
(12 G codes for each path, on the 14 CRT when two–path control is being
used)
During automatic operation, the actual speed, SCAT, and repeat count are
displayed. The key input prompt (u_) is displayed otherwise.
Explanations
D Program display
D Current position display
D Modal G codes
D Displaying during
automatic operation

Leave a Reply

Your email address will not be published. Required fields are marked *