FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
656
4 If a comment already exists in the block containing the program
number of a program whose machining time is to be inserted, the
machining time is inserted after the existing comment.
O0100 (SHAFT XSF001) ;
N10 G92 X100. Z10. ;
N20 S1500 M03 ;
N30 G00 X20.5 Z5. T0101 ;
N40 G01 X–10. F25. ;
N50 G02 X16.5 Z–12. R2. ;
N60 G01 X40. ;
N70 X42. Z–13. ;
N80 Z–50. ;
N90 X44. Z–51. ;
N100 X80. ;
EDIT *** *** *** *** 16:52:13
[
INS–TM ][ ][ ][ ][ ]
PROGRAM O0100 N0000
O0100 (SHAFT XSF001)(001H20M01S) ;
N10 G92 X100. Z10. ;
N20 S1500 M03 ;
N30 G00 X20.5 Z5. T0101 ;
N40 G01 Z–10. F25. ;
N50 G02 X16.5 Z–12. R2. ;
N60 G01 X40. ;
N70 X42. Z–13. ;
N80 Z–50. ;
N90 X44. Z–51. ;
N100 X80. ;
EDIT *** *** *** *** 16:52:13
[
INS–TM ][ ][ ][ ][ ]
PROGRAM O0100 N0000
5 The machining time of a program inserted as a comment can be
displayed after an existing program comment on the program
directory screen.
O0020 (GEAR XGR001 ):(012H48M01S)
O0002 (GEAR XGR002 ):(000H48M01S)
O0010 (BOLT YBT001 ):(004H16M01S)
O0020 (BOLT YBT002 ):(000H16M01S)
O0040 (SHAFT XSF001 ):(001H20M01S)
O0050 (SHAFT XSF002 ):(002H08M01S)
O0100 (SHAFT XSF011 ):(002H32M02S)
O0200 (PLATE XPL100 ):(000H51M01S)
PROGRAM DIRECTORY O0001 N00010
PROGRAM(NUM.) MEMORY(CHAR.)
USED: 60 3321
FREE: 2 429
>_
EDIT **** *** *** 14:46:09
[ PRGRM ][ DIR ][ ][ ][ (OPRT) ]

Leave a Reply

Your email address will not be published. Required fields are marked *