FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
664
PROGRAM NO. USED
PROGRAM NO. USED : The number of the programs registered
(including the subprograms)
FREE : The number of programs which can be
registered additionally.
MEMORY AREA USED
MEMORY AREA USED : The capacity of the program memory in which
data is registered (indicated by the number of
characters).
FREE : The capacity of the program memory which
can be used additionally (indicated by the
number of characters).
Program Nos. registered are indicated.
Also, the program name can be displayed in the program table by setting
parameter NAM (No. 3107#0) to 1.
O0001 (MACRO–GCODE.MAIN)
O0002 (MACRO–GCODE.SUB1)
O0010 (TEST–PROGRAM.ARTHMETIC NO.1)
O0020 (TEST–PROGRAM.F10–MACRO)
O0040 (TEST–PROGRAM.OFFSET)
O0050
O0100 (INCH/MM CONVERT CHECK NO.1)
O0200 (MACRO–MCODE.MAIN)
> _
EDIT **** *** *** 16:05:59
[ PRGRM ][ DIR ][ ][ C.A.P. ][ (OPRT) ]
PROGRAM DIRECTORY O0001 N00010
PROGRAM(NUM.) MEMORY(CHAR.)
USED: 60 3321
FREE: 2 429
Always enter a program name between the control out and control in
codes immediately after the program number.
Up to 31 characters can be used for naming a program within the
parentheses. If 31 characters are exceeded, the exceeded characters are
not displayed.
Only program number is displayed for the program without any program
name.
(fffff)f VVVV
;
Program number
Program name (up to 31 characters)
Software series of the system is displayed.
It is used for maintenance ; user is not required this information.
Programs are displayed in the same order that they are registered in the
program library list. However, if bit 4 (SOR) of parameter 3107 is set to
1, programs are displayed in the order of program number starting from
the smallest one.
Explanations
D Details of memory used
D Program library list
D Program name
D Software series
D Order in which programs
are displayed in the
program library list

Leave a Reply

Your email address will not be published. Required fields are marked *