FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
666
In two–path control, the programs for both tool posts can be displayed and
edited on the same screen when bit 0 (DHD) of parameter No. 3106 is set
to 1.
The name of each tool post is displayed above the corresponding program.
Procedure for Two–path Simultaneous Editing on the Program Screen
1 Specify EDIT mode for both tool posts.
2 Press function
PROG
key.
>N130T0100;M30;
EDIT **** *** *** 16:05:59 HEAD1
[ BG–EDT ][ O SRH ][ SRH + ][ SRH – ][ REWIND ]
PROGRAM O1357 N00120 O2468 N00130
(HEAD1) (HEAD2)
O1357 (HEAD–1 MAIN PROGRAM);
N010 G90 G00 X200.0 Z220.0 ;
N020 T0101 ;
N030 S30000 M03 ;
N040 G40 G00 X40.0 Z180.0 ;
N050 G01 Z140.0 F1000.0 ;
N060 X60.0 Z110.0 ;
N070 Z90.0 ;
N080 X100.0 Z80.0 ;
N090 Z60.0 ;
N100 X140.0 Z40.0 ;
N110 X200.0 Z220.0 ;
N120 S0 M05 ;
O2468 (HEAD–2 MAIN PROGRAM);
N010 G90 G00 X200.0 Z220.0 ;
N020 T0101 ;
N030 S30000 M03 ;
N040 G41 G00 X40.0 Z180.0 ;
N050 G01 Z140.0 F1000.0 ;
N060 X60.0 Z110.0 ;
N070 Z90.0 ;
N080 X100.0 Z80.0 ;
N090 Z60.0 ;
N100 X140.0 Z40.0 ;
N110 X200.0 Z220.0 ;
N120 T0100 ;
N130 T0102 ;
N140 S1000 ;
N150 G41 G00 X40.0 Z180.0 ;
>_
EDIT STRT MIN FIN ALM 17:25:01 HEAD1
[ ][ ][ ][ ][ ][ ] [PRGRM][ LIB ][ ][ ][(OPR)][ ]
PROGRAM O1234 N00010 O2345 N00100
(HEAD1) (HEAD2)
O1234 ;
N10 G00 ;
N20 X100.0 ;
N30 X200.0 ;
N40 X300.0 Z300.0 ;
N50 X400.0 ;
N60 X500.0 ;
N70 M02 ;
%
O2345;
N100 G00 ;
N200 X0 ;
N300 X50.0 ;
N400 M02 ;
%
11.3.2
Two–path
simultaneous editing
on the program screen
Shared screen
(9 CRT/PDP, 8.4 LCD)
Shared screen
(14 CRT, 9.5 LCD)

Leave a Reply

Your email address will not be published. Required fields are marked *