FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
667
When the selected tool post is in EDIT mode, pressing the [PRGRM] soft
key displays a shared screen which shows the program for the first tool
post on the left and that for the second tool post on the right. However,
if the tool post that is not selected fails to satisfy any of the conditions
described below, only the individual screen for the selected tool post is
displayed.
<Conditions>
Bit 0 (DHD) of parameter No. 3106 is set to 1.
The program screen for the selected tool post is the 14 type
(when the 14 CRT is being used).
Both tool posts are set to EDIT mode.
Background editing is not specified for either tool post.
When the mode for the tool post that is not selected is changed from
EDIT
mode on the shared screen, the individual screen (14 type when the 14
CRT is being used) for the selected tool post is displayed.
On the 14 CRT, pressing the
[PRGRM] soft key toggles between the
individual screen (9 type) and the shared screen.
>_
EDIT STRT MIN FIN ALM 17:25:01 HEAD1
[ ][ ][ ][ ][ ][ ] [PRGRM][ LIB ][ ][ ][(OPR)][ ]
PROGRAM O1234 N00010 O2345 N00100
(HEAD1) (HEAD2)
O1234 ;
N10 G00 ;
N20 X100.0 ;
N30 X200.0 ;
N40 X300.0 Z300.0 ;
N50 X400.0 ;
N60 X500.0 ;
N70 M02 ;
%
O2345;
N100 G00 ;
N200 X0 ;
N300 X50.0 ;
N400 M02 ;
%
Individual screen (9 CRT)
Explanations
D Shared screen and
individual screen

Leave a Reply

Your email address will not be published. Required fields are marked *