FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
673
Dedicated screens are provided for displaying and setting tool offset
values and tool nose radius compensation values.
Procedure for setting and displaying the tool offset value and the tool nose radius
compensation value
1 Press function key
OFFSET
SETTING
.
For the two–path control, select the tool post for which tool
compensation values are to be displayed with the tool post selection
switch.
2 Press chapter selection soft key
[OFFSET] or press
OFFSET
SETTING
several
times until the tool compensation screen is displayed.
Different screens are displayed depending on whether tool geometry
offset, wear offset, or neither is applied.
OFFSET O0001 N00000
NO. X Z. R T
001 0.000 10.000 0.000 0
002 0.000 0.000 0.000 0
003 0.000 0.000 0.000 0
004 40.000 –40.000 0.000 0
005 0.000 0.000 0.000 0
006 0.000 0.000 0.000 0
007 0.000 0.000 0.000 0
008 0.000 0.000 0.000 0
ACTUAL POSITION (RELATIVE)
U 101.000 W 202.094
Without tool geometry/wear offset
> _
MDI **** *** *** 16:05:59
[ OFFSET ][ SETING ][ WORK ][ ][ (OPRT) ]
OFFSET/GEOMETRY O0001 N00000
NO. X Z. R T
G 001 0.000 1.000 0.000 0
G 002 1.486 –49.561 0.000 0
G 003 1.486 –49.561 0.000 0
G 004 1.486 0.000 0.000 0
G 005 1.486 –49.561 0.000 0
G 006 1.486 –49.561 0.000 0
G 007 1.486 –49.561 0.000 0
G 008 1.486 –49.561 0.000 0
ACTUAL POSITION (RELATIVE)
U 101.000 W 202.094
> _
MDI **** *** *** 16:05:59
[ WEAR ][ GEOM ][ WORK ][ ][ (OPRT) ]
With tool geometry offset
11.4.1
Setting and Displaying
the Tool Offset Value

Leave a Reply

Your email address will not be published. Required fields are marked *