FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
683
Tool position offset values along the Y–axis can be set. Counter input of
offset values is also possible.
Direct input of tool offset value and direct input function B for tool offset
measured are not available for the Y–axis.
Procedure for setting the tool offset value of the Y axis
1 Press function key
OFFSET
SETTING
.
2 Press the continuous menu key
several times until the screen
with soft key
[OFST.2] is displayed.
3 Press soft key
[OFST.2].
The Y axis offset screen is displayed.
OFFSET O0001 N00000
NO. Y
01 10.000
02 0.000
03 0.000
04 40.000
05 0.000
06 0.000
07 0.000
08 0.000
ACTUAL POSITION (RELATIVE)
U 100.000 W 100.000
>_
MDI **** *** *** 16:05:59
[ OFST.2 ][ W.SHFT ][ ][ ][ (OPRT) ]
3–1 Press soft key [GEOM] to display the tool geometry
compensation values along the Y–axis.
OFFSET/GEOMETRY O0001 N00000
NO. Y
G 01 10.000
G 02 0.000
G 03 0.000
G 04 40.000
G 05 0.000
G 06 0.000
G 07 0.000
G 08 0.000
ACTUAL POSITION (RELATIVE)
U 100.000 W 100.000
>_
MDI **** *** *** 16:05:59
[ WEAR ][ GEOM ][ ][ ][ (OPRT) ]
11.4.6
Y Axis Offset

Leave a Reply

Your email address will not be published. Required fields are marked *