FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
685
Procedure for counter input of the offset value
To set relative coordinates along the Y–axis as offset values:
1 Move the reference tool to the reference point.
2 Reset relative coordinate Y to 0 (see subsec. III–11.1.2).
3 Move the tool for which offset values are to be set to the reference
point.
4 Move the cursor to the value for the offset number to be set, press
Y
, then press soft key [INP.C.].
Relative coordinate Y (or V) is now set as the offset value.

Leave a Reply

Your email address will not be published. Required fields are marked *