FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
694
5 To display the workpiece origin offset setting screen, press the
chapter selection soft key
[WORK].
NO. DATA NO. DATA
00 X 0.000 02 X 0.000
(EXT) Z 0.000 (G55)Z 0.000
01 X 0.000 03 X 0.000
(G54) Z 0.000 (G56) Z 0.000
WORK COORDINATES O1234 N56789
(G54)
> Z100. S 0 T0000
MDI **** *** *** 16:05:59
[ NO.SRH ][ MEASUR ][ ][ +INPUT ][ INPUT ]
6 Position the cursor to the workpiece origin offset value to be set.
7 Press the address key for the axis along which the offset is to be set
(Z–axis in this example).
8 Enter the measured value (α) then press the
[MEASUR] soft key.
9 Cut surface B manually.
10 Move the tool along the Z axis without changing the X coordinate
then stop the spindle.
11 Measure the diameter of surface A (α) then enter the diameter at X.
Offsets for two or more axes cannot be input at the same time.
This function cannot be used while a program is being executed.
Any shift specified for the workpiece coordinate system or external offset
remains effective when this function is used.
Restrictions
D Consecutive input
D During program
execution
D Effect from other shift
value

Leave a Reply

Your email address will not be published. Required fields are marked *