FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
696
With this function, functions of the switches on the machine operators
panel can be controlled from the CRT/MDI panel.
Jog feed can be performed using numeric keys.
Procedure for displaying and setting the software operators panel
1 Press function key
OFFSET
SETTING
.
2 Press the continuous menu key
, then press chapter selection soft
key
[OPR].
3 The screen consists of several pages.
Press page key
PAGE
or
PAGE
until the desired screen is displayed.
OPERATOR’S PANEL O0000 N00000
MODE : MDI MEM EDIT HND JOG REF
HANDLE AXIS : HX HZ HC HY
STEP MULTI. :
*1 *10 *100
RAPID OVRD. : 100% 50% 25% F0
JOG OVRD : 2.0%
**************
FEED OVRD. : 100%
***
ACTUAL POSITION (ABSOLUTE)
X 0.000 Z 0.000
>_
REF **** *** *** 16:05:59
[ MACRO ][ MEMu ][ OPR ][ ][ ]
OPERATOR’S PANEL O0000 N00000
BLOCK SKIP : OFF J ON
SINGLE BLOCK : J OFF ON
MACHINE LOCK : OFF J ON
PROTECT KEY : J PROTECT RELEASE
FEED HOLD : J OFF
ACTUAL POSITION (ABSOLUTE)
X 0.000 Z 0.000
MDI **** *** *** 16:05:59
[ MACRO ][ MENU ][ OPR ][ ][ ]
4 Move the cursor to the desired switch by pressing cursor key or
.
11.4.13
Displaying and Setting
the Software
Operators Panel
OPR
Continuous menu key

Leave a Reply

Your email address will not be published. Required fields are marked *