FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
700
TOOL LIFE DATA : O3000 N00060
SELECTED GROUP 000
GROUP 001 : LIFE 0150 COUNT 0007
*0034 #0078 @0012 0056
0090 0035 0026 0061
0000 0000 0000 0000
0000 0000 0000 0000
GROUP 002 : LIFE 1400 COUNT 0000
0062 0024 0044 0074
0000 0000 0000 0000
0000 0000 0000 0000
0000 0000 0000 0000
TO BE CHANGED : 003 004 005 006 –––>
> _
MEM **** *** *** 16:05:59
[ MACRO ][ ][ OPR ][ TOOLLF ][ (OPRT) ]
D The first line is the title line.
D In the second line the group number of the current command is
displayed.
When there is no group number of the current command, 0 is
displayed.
D In lines 3 to 7 the tool life data of the group is displayed.
The third line displays group number, life and the count used.
The life count is chosen by parameter LTM (No. 6800#2) as either
minutes(or hours) or number of times used.
In lines 4 to 7, tool numbers are displayed. In this case, the tool is
selected in the order, 0034 0078 0012 056 0090 ...
The meaning of each mark before the tool numbers is :
* : Shows the life has finished.
# : Shows that the skip command has been accepted.
@ : Shows that the tool is currently being used.
The life counter counts for tool with @.
“*” is displayed when the next command is issued by the group to
which it belongs.
D Lines 8 to 12 are next group life data to the group displayed in lines
3 to 7.
D In the thirteenth line the group number when the tool change signal is
being emitted is displayed. The group number display appears in
ascending order. When it cannot be completely displayed, “–––>” is
displayed.
D  

Leave a Reply

Your email address will not be published. Required fields are marked *