FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
705
Procedure for enabling/displaying parameter writing
1 Select the MDI mode or enter state emergency stop.
2 Press function key
OFFSET
SETTING
.
3 Press soft key [SETING] to display the setting screen.
SETTING (HANDY) O0001 N00000
> _ S 0 T0000
MDI **** *** *** 16:05:59
[ OFFSET ][ SETING ][ WORK ][ ][ (OPRT) ]
PARAMETER WRITE = 1 (0:DISABLE 1:ENABLE)
TV CHECK = 0 (0:OFF 1:ON)
PUNCH CODE = 1 (0:EIA 1:ISO)
INPUT UNIT = 0 (0:MM 1:INCH)
I/O CHANNEL = 0 (0–3:CHANNEL NO.)
SEQUENCE NO. = 0 (0:OFF 1:ON)
TAPE FORMAT = 0 (0:NO CNV 1:F10/11)
SEQUENCE STOP = 0 (PROGRAM NO.)
SEQUENCE STOP = 11 (SEQUENCE NO.)
4 Move the cursor to PARAMETER WRITE using cursor keys.
5 Press soft key
[(OPRT)], then press [1: ON] to enable parameter
writing.
At this time, the CNC enters the P/S alarm state (No. 100).
6 After setting parameters, return to the setting screen. Move the cursor
to
PARAMETER WRITE and press soft key [(OPRT)] , then press
[0: OFF].
7 Depress the
RESET
key to release the alarm condition. If P/S alarm No.
000 has occurred, however, turn off the power supply and then turn it
on, otherwise the P/S alarm is not released.
See Chapter 8 for setting parameters with external input/output devices
such as the Handy File.
Some parameters are not effective until the power is turned off and on
again after they are set. Setting such parameters causes alarm 000. In this
case, turn off the power, then turn it on again.
Refer to the FANUC Series 16/18160/180–MODEL C Parameter Manual
(B–62760EN) for the parameter list.
Some parameters can be set on the setting screen if the parameter list
indicates “Setting entry is acceptable”. Setting 1 for
PARAMETER
WRITE
is not necessary when three parameters are set on the setting
screen.
Explanations
D Setting parameters with
external input/output
devices
D Parameters that require
turning off the power
D Parameter list
D  

Leave a Reply

Your email address will not be published. Required fields are marked *