FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
708
The program number, sequence number, and current CNC status are
always displayed on the screen except when the power is turned on, a
system alarm occurs, or the PMC screen is displayed.
If data setting or the input/output operation is incorrect, the CNC does not
accept the operation and displays a warning message.
This section describes the display of the program number, sequence
number, and status, and warning messages displayed for incorrect data
setting or input/output operation.
The program number and sequence number are displayed at the top right
on the screen as shown below.
O1000
N100 G50 X0 Z0. ;
N101 G00 X100. Z50. ;;
N102 G01 X230. Z56. ;
N103 W–10. ;
N104 U–120. ;
N105 M02 ;
> _
EDIT **** *** *** 16:05:59
[ PRGRM ][ CHECK ][ CURRNT ][ NEXT ][ (OPRT) ]
PROGRAM O2000 N00130
Sequence No.
Program No.
The program number and sequence number displayed depend on the
screen and are given below:
On the program screen in the EDIT mode on Background edit screen:
The program No. being edited and the sequence number just prior to
the cursor are indicated.
Other than above screens :
The program No. and the sequence No. executed last are indicated.
Immediately after program number search or sequence number
search :
Immediately after the program No. search and sequence No. search,
the program No. and the sequence No. searched are indicated.
11.6
DISPLAYING THE
PROGRAM NUMBER,
SEQUENCE
NUMBER, AND
STATUS, AND
WARNING
MESSAGES FOR
DATA SETTING OR
INPUT/OUTPUT
OPERATION
11.6.1
Displaying the
Program Number and
Sequence Number

Leave a Reply

Your email address will not be published. Required fields are marked *