FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62754EN/01
710
ALM
: Indicates that an alarm is issued. (Blinks in reversed display.)
BAT
: Indicates that the battery is low. (Blinks in reversed display.)
Space : Indicates a state other than the above.
hh:mm:ss – Hours, minutes, and seconds
INPUT : Indicates that data is being input.
OUTPUT : Indicates that data is being output.
SRCH : Indicates that a search is being performed.
EDIT : Indicates that another editing operation is being performed
(insertion, modification, etc.)
LSK : Indicates that labels are skipped when data is input.
RSTR : Indicates that the program is being restarted
Space : Indicates that no editing operation is being performed.
When invalid data is entered (wrong format, value out of range, etc.),
when input is disabled (wrong mode, write disabled, etc.), or when
input/output operation is incorrect (wrong mode, etc.), a warning message
is displayed. In this case, the CNC does not accept the setting or
input/output operation.
The following are examples of warning messages:
(Display soft keys)
Example 1)
When a parameter is entered
> 1
EDIT WRONG MODE
(Display soft keys)
Example 2)
When a parameter is entered
> 999999999
MDI TOO MANY DIGITS
(Display soft keys)
Example 3)
When a parameter is output to an external input/output device
> _
MEM WRONG MODE
HEAD1 : Tool post 1 is selected.
HEAD2 : Tool post 2 is selected.
Other names can be used depending on the settings of parameters 3141
to 3147.
The tool post name is displayed at the position where
(8) is now displayed.
While the program is edited,
(8) is displayed.
D (6) Alarm status
D (7) Current time
D (8) Program editing
status
D (9) Warning for data
setting or input/
output operation
D (10) Tool post name
(for the two–path
control)

Leave a Reply

Your email address will not be published. Required fields are marked *