FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
11. SETTING AND DISPLAYING DATA
711
By pressing the MESSAGE function key, data such as alarms, alarm
history data, and external messages can be displayed.
For information relating to alarm display, see Section III.7.1. For
information relating to alarm history display, see Section III.7.2.
For information relating to external message display, see the relevant
manual supplied by the machine tool builder.
External operator messages can be preserved as history data.
Preserved history data can be displayed on the external operator message
history screen.
Procedure for external operator message history display
1 Press the
MESSAGE
function key.
2 Press the continuous menu key
, then press the chapter selection
soft key [MSGHIS]. The screen shown below appears.
MESSAGE HISTORY O0000 N00000
94/01/01 17:25:00 PAGE:1
NO. ****
MEM STRT MIN FIN ALM 09:36:48
[ ][ MSGHIS ][ PUNCH ][ ][ (OPRT) ]
Date and Page number
Message nuumber
Display range
(Up to 255 characters)
NOTE
Up to 255 characters can be specified for an external
operator message. By setting MS1 and MS0 (bits 7 and 6
of parameter No. 3113), however, the number of characters
that can be preserved as external operator message history
data can be restricted, and the number of history data items
selected.
11.7
SCREENS DISPLAYED
BY FUNCTION KEY me
MESSAGE
11.7.1
External Operator
Message History
Display

MSGHIS
Continuous menu key

Leave a Reply

Your email address will not be published. Required fields are marked *