FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
12. GRAPHICS FUNCTION
B–62754EN/01
718
Part of a drawing on the screen can be magnified.
8 Press the
GRAPH
function key, then the [ZOOM] soft key to display a
magnified drawing. The magnified–drawing screen contains two
zoom cursors (J)
0001
00021
X 200.000
Z 200.000
X
Z
S 0.55
W150000
D 150000
>_
MEM STRT **** FIN 12:12:24
[ G.PRM ][ ][ GRAPH ][ ZOOM ][ (OPRT) ]
A rectangle that has one of its diagonals defined by the two zoom
cursors is magnified to the full size of the screen.
For the two–path control, the zoom cursors are indicated for the
selected tool post. Use the tool post select switch to select the tool
post corresponding to the drawing to be magnified.
9 Using the cursor keys
, move the zoom cursors
to specify a diagonal for the new screen. Pressing the
[HI / LO] soft
key toggles the zoom cursor to be moved.
10 To make the original drawing disappear, press
[EXEC].
11 Resume the previous operation. The part of the drawing specified
with the zoom cursors will be magnified.
0001
00012
X 200.000
Z 200.000
X
Z
S 0.81
>_
MEM STRT **** FIN 12:12:24
[ G.PRM ][ GRAPH ][ ][ ][ ]
12 To display the original drawing, press the [NORMAL] soft key, then
start automatic operation.
D Magnifying drawings

Leave a Reply

Your email address will not be published. Required fields are marked *