FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
12. GRAPHICS FUNCTION
719
Parameter No. 6510 is used to set a drawing coordinate system for using
the graphic function. The relationships between setting values and
drawing coordinate systems are indicated below. With two–path control,
a different drawing coordinate system can be selected for each tool post.
Setting value=0 Setting value=1 Setting value=2 Setting value=3
Setting value=4 Setting value=5 Setting value=6 Setting value=7
X
Z
Z
Z
Z
Z
Z
Z
Z
X
X
X
X
X
X
X
WORK LENGTH (W), WORK DIAMETER (D)
Specify work length and work diameter. The table below lists the input
unit and valid data range.
W
D
X
Z
W
D
Z
X
Table 12.1 Unit and Range of Drawing Data
Increment system
Unit
Valid range
Increment
system
mm input Inch input
Valid
range
IS–B 0.001 mm 0.0001 inch
0 to 99999999
IS–C 0.0001 mm 0,00001 inch
0
to
99999999
Explanation
D Setting drawing
coordinate systems
D Graphics parameter

Leave a Reply

Your email address will not be published. Required fields are marked *