FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
13. HELP FUNCTION
725
Fig.13(g) How to select each OPERATION METHOD screen
>1 S 0 T0000
MEM **** *** *** 10:12:25
[ ][ ][ ][ ][ SELECT ]
When “1. PROGRAM EDIT” is selected, for example, the screen in
Figure 13 (g) is displayed.
On each
OPERATION METHOD screen, it is possible to change the
displayed page by pressing the PAGE key. The current page No. is
shown at the upper right corner on the screen.
HELP (OPERATION METHOD) 01234 N00001
<< 1. PROGRAM EDIT >> 1/4
*DELETE ALL PROGRAMS
MODE : EDIT
SCREEN : PROGRAM
OPR : (O–9999) – <DELETE>
*DELETE ONE PROGRAM
MODE : EDIT
SCREEN : PROGRAM
OPR : (O+PROGRAM NUMBER) – <DELETE>
Each item
Page/maximum
page
Operation
Set mode
Operation location
Operating
procedure
Fig.13(h) Selected OPERATION METHOD screen
>_ S 0 T0000
MEM **** *** *** 10:12:25
[ 1 ALM ][ 2 OPR ][ 3 PARA ][ ][ ]
5 To return to the OPERATION METHOD menu screen, press the
RETURN MENU key to display “[2 OPR]” again, and then press the
[2 OPR] key again.
To directly select another
OPERATION METHOD screen on the
screen shown in Figure 13 (h), enter an item No. from the keyboard
and press the
[SELECT] key
>3 S 0 T0000
MEM **** *** *** 10:12:25
[ ][ ][ ][ ][ SELECT ]
Fig.13(i) How to select another OPERATION METHOD screen
6 If you are not sure of the No. of a system parameter to be set, or to refer
to a system parameter, press the
[3 PARA] key on the HELP (INITIAL
MENU)
screen. A list of parameter Nos. for each function is
displayed. (See Figure 13 (j).)
It is possible to change the displayed page on the parameter screen.
The current page No. is shown at the upper right corner on the screen.
RETURN MENU key
PARAMETER TABLE screen

Leave a Reply

Your email address will not be published. Required fields are marked *