FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

APPENDIX
A. TAPE CODE LIST
B–62754EN/01
736
ISO code EIA code Meaning
Character 8 7 6 5 4 3 2 1 Character 8 7 6 5 4 3 2 1
Without custom
macro B
With custom
macro B
DEL f f f f f f f f f Del f f f f f f f f × ×
NUL f Blank f × ×
BS f f f BS f f f f × ×
HT f f f Tab f f f f f f × ×
LF or NL f f f CR or EOB f f
CR f f f f f ___ × ×
SP f f f SP f f j j
% f f f f f ER f f f f
( f f f (2–4–5) f f f f
) f f f f f (2–4–7) f f f f
+ f f f f f + f f f f
f f f f f f f
: f f f f f ___
/ f f f f f f f / f f f f
. f f f f f . f f f f f f
# f f f f f
Parameter
(No.6012)
$ f f f ___ f
& f f f f f & f f f f f
f f f f f ___ f
* f f f f f
Parameter
(No.6010)
, f f f f f , f f f f f f
; f f f f f f f ___
< f f f f f ___
= f f f f f f f
Parameter
(No.6011)
> f f f f f f f ___
? f f f f f f f ___ f
@ f f f ___ f
f f ___
[ f f f f f f f
Parameter
(No.6013)
] f f f f f f f
Parameter
(No.6014)
NOTE
1 The symbols used in the remark column have the following meanings.
(Space) : The character will be registered in memory and has a specific meaning.
If it is used incorrectly in a statement other than a comment, an alarm occurs.
: The character will not be registered in memory, but will be ignored.
n : The character will be registered in memmory, but will be ignored during program
execution.
Ę: The character will be registered in memory. If it is used in a statement other than a
comment, an alarm occurs.
V : If it is used in a statement other than a comment, the character will not be registered
in memory. If it is used in a comment, it will be registered in memory.
2 Codes not in this table are ignored if their parity is correct.
3 Codes with incorrect parity cause the TH alarm. But they are ignored without generating
the TH alarm when they are in the comment section.
4 A character with all eight holes punched is ignored and does not generate TH alarm in
EIA code.

Leave a Reply

Your email address will not be published. Required fields are marked *