FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

APPENDIX
E. STATUS WHEN TURNING POWER ON,
WHEN CLEAR AND WHEN RESET
B–62754EN/01
752
E
STATUS WHEN TURNING POWER ON, WHEN CLEAR
AND WHEN RESET
Parameter 3402 (CLR) is used to select whether resetting the CNC places
it in the cleared state or in the reset state (0: reset state/1: cleared state).
The symbols in the tables below mean the following :
f:The status is not changed or the movement is continued.
×:The status is cancelled or the movement is interrupted.
Item When turning power on Cleared Reset
Setting
data
Offset value f f f
data
Data set by the
MDI setting opera-
tion
f f f
Parameter f f f
Various
data
Programs in
memory
f f f
Contents in the
buffer storage
× × f : MDI mode
× : Other mode
Display of se-
quence number
f f (Note 1) f (Note 1)
One shot G code × × ×
Modal G code Initial G codes.
(The G20 and G21 codes
return to the same state they
were in when the power was
last turned off.)
Initial G codes.
(G20/G21 are not
changed.)
f
F Zero Zero f
S, T, M × f f
K (Number of re-
peats)
× × ×
Work coordinate value Zero f f

Leave a Reply

Your email address will not be published. Required fields are marked *