FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

APPENDIX
B–62754EN/01
E. STATUS WHEN TURNING POWER ON,
WHEN CLEAR AND WHEN RESET
753
Item ResetClearedWhen turning power on
Action in
Movement × × ×
opera-
tion
Dwell × × ×
tion
Issuance of M, S
and T codes
× × ×
Tool offset × Depending on param-
eter LVK(No.5003#6)
f : MDI mode
Other modes depend
on parameter
LVK(No.5003#6).
Tool nose radius
compensation
× × f : MDI mode
× : Other modes
Storing called sub-
program number
× × (Note 2) f : MDI mode
× : Other modes (Note
2)
Output
signals
CNC alarm signal
AL
Extinguish if there is no
cause for the alarm
Extinguish if there is
no cause for the alarm
Extinguish if there is
no cause for the alarm
Reference position
return completion
LED
× f (× : Emergency
stop)
f (× : Emergency
stop)
S, T and B codes × f f
M code × × ×
M, S and T strobe
signals
× × ×
Spindle revolution
signal (S analog
signal)
× f f
CNC ready signal
MA
ON f f
Servo ready signal
SA
ON (When other than ser-
vo alarm)
ON (When other than
servo alarm)
ON (When other than
servo alarm)
Cycle start LED
(STL)
× × ×
Feed hold LED
(SPL)
× × ×
NOTE
1 When heading is performed, the main program number is
displayed.
2 When a reset is performed during execution of a
subprogram, control returns the main program.
Execution cannot be started from the middle of the
subprogram.

Leave a Reply

Your email address will not be published. Required fields are marked *