FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

APPENDIX
B–62754EN/01
G. ALARM LIST
757
Number ContentsMessage
059 PROGRAM NUMBER NOT FOUND In an external program number search or external workpiece number
search, a specified program number was not found. Otherwise, a
program specified for searching is being edited in background pro-
cessing. Check the program number and external signal. Or discon-
tinue the background editing.
060 SEQUENCE NUMBER NOT FOUND Commanded sequence number was not found in the sequence num-
ber search. Check the sequence number.
061 ADDRESS P/Q NOT FOUND IN
G70–G73
Address P or Q is not specified in G70, G71, G72, or G73 command.
Modify the program.
062 ILLEGAL COMMAND IN G71–G76 1 The depth of cut in G71 or G72 is zero or negative value.
2 The repetitive count in G73 is zero or negative value.
3 The negative value is specified toi ork is zero in G74 or G75.
4 A value other than zero is specified to address U or W, thoughi
ork is zero in G74 or G75.
5 A negative value is specified tod, though the relief direction in
G74 or G75 is determined.
6 Zero or a negative value is specified to the height of thread or
depth of cut of first time in G76.
7 The specified minimum depth of cut in G76 is greater than the
height of thread.
8 An unusable angle of tool tip is specified in G76.
Modify the program.
063 SEQUENCE NUMBER NOT FOUND The sequence number specified by address P in G70, G71, G72, or
G73 command cannot be searched. Modify the program.
064 SHAPE PROGRAM NOT
MONOTONOUSLY
A target shape which is not monotonous increase or decrease was
specified in a repetitive canned cycle (G71 or G72).
065 ILLEGAL COMMAND IN G71–G73 1 G00 or G01 is not commanded at the block with the sequence
number which is specified by address P in G71, G72, or G73 com-
mand.
2 Address Z(W) or X(U) was commanded in the block with a se-
quence number which is specified by address P in G71 or G72,
respectively.
Modify the program.
066 IMPROPER G–CODE IN G71–G73 An unallowable G code was commanded between two blocks speci-
fied by address P in G71, G72, or G73. Modify the program.
067 CAN NOT OPERATE IN MDI MODE G70, G71, G72, or G73 command with address P and Q was speci-
fied.
Modify the program.
069 FORMAT ERROR IN G70–G73 The final move command in the blocks specified by P and Q of G70,
G71, G72, or G73 ended with chamfering or corner R.
070 NO PROGRAM SPACE IN
MEMORY
The memory area is insufficient.
Delete any unnecessary programs, then retry.
071 DATA NOT FOUND The address to be searched was not found. Or the program with
specified program number was not found in program number search.
Check the data.
072 TOO MANY PROGRAMS The number of programs to be stored exceeded 63 (basic), 125 (op-
tion), 200 (option), 400 (option), or 1000 (option). Delete unnecessary
programs and execute program registration again.
073 PROGRAM NUMBER ALREADY IN
USE
The commanded program number has already been used.
Change the program number or delete unnecessary programs and
execute program registration again.

Leave a Reply

Your email address will not be published. Required fields are marked *