FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

APPENDIX
G. ALARM LIST
B–62754EN/01
764
Number ContentsMessage
5031 ILLEGAL COMMAND (G100, G102,
G103)
While a registration start command (G101, G102, or G103) was being
executed, another registration start command was specified for the
B–axis.
5032 NEW PRG REGISTERED IN B–AXS
MOVE
While the machine was moving about the B–axis, at attempt was
made to register another move command.
5033 NO PROG SPACE IN MEMORY
B–AXIS
Commands for movement about the B–axis were not registered be-
cause of insufficient program memory.
5034 PLURAL COMMAND IN G110 Multiple movements were specified with the G110 code for the B–
axis.
5035 NO FEEDRATE COMMANDED
B–AXIS
A feedrate was not specified for cutting feed about the B–axis.
5036 ADDRESS R NOT DEFINED IN
G81–G86
Point R was not specified for the canned cycle for the B–axis.
5037 ADDRESS Q NOT DEFINED IN G83 Depth of cut Q was not specified for the G83 code (peck drilling
cycle). Alternatively, 0 was specified in Q for teh B–axis.
5038 TOO MANY START M–CODE
COMMAND
More than six M codes for starting movement about the B–axis were
specified.
5039 START UNREGISTERED B–AXIS
PROG
An attempt was made to execute a program for the B–axis which had
not been registered.
5040 CAN NOT COMMANDED B–AXIS
MOVE
The machine could not move about the B–axis because parameter
No.8250 was incorrectly specified, or because the PMC axis system
could not be used.
5041 CAN NOT COMMANDED G110
BLOCK
Blocks containing the G110 codes were successively specified in
tool–tip radius compensation for the B–axis.
5046 ILLEGAL PARAMETER (ST.COMP) Parameters related to straightness compensation have been erro-
neously specified. Possible causes are as follows :
1 Invalid axis numbers have been assigned to move or compensa-
tion axes.
2 The number of pitcherror compensation points between the maxi-
mum positive and maximum negative points exceeds 128.
3 Straightness compensation point numbers have been assigned in
other than ascending order.
4 Straightness compensation points could not belocated between the
maximum positive and maximum negative pitch error compensa-
tion points.
5 The amount of compensation per compensation point is too large
or too small.
5051 M–NET CODE ERROR Abnormal character reception
(Characters except code used to transmit)
5052 M–NET ETX ERROR “ETX” code is abnormal.
5053 M–NET CONNECT ERROR Connection time supervision error (parameter No.175)
5054 M–NET RECEIVE ERROR Boring time supervision error (parameter No.176)
5055 M–NET PRT/FRM ERROR Vertical parity or framing error detection
5056 M–NET BOARD SYSTEM DOWN Transmit time–out error (parameter No. 177)
ROM parity error
CPU interruption detection of not listed above
5058 G35/G36 FORMAT ERROR A command for changing the major axis was specified during circular
threading. Alternatively, the leangth of the major axis was specified
to be 0.
5059 RADIUS IS OUT OF RANGE During circular interpolation, the center of the arc specified with I, J,
and K caused the radius to exceed nine digits.

Leave a Reply

Your email address will not be published. Required fields are marked *