FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
5. FEED FUNCTIONS
B–62754EN/01
78
G00 _ ;
G00 : G code (group 01) for positioning (rapid traverse)
_ ; Dimension word for the end point
The positioning command (G00) positions the tool by rapid traverse. In
rapid traverse, the next block is executed after the specified feedrate
becomes 0 and the servo motor reaches a certain range set by the machine
tool builder (in–position check).
A rapid traverse rate is set for each axis by parameter No. 1420, so no rapid
traverse feedrate need be programmed.
The following overrides can be applied to a rapid traverse rate with the
switch on the machine operators panel:F0, 25, 50, 100%
F0: Allows a fixed feedrate to be set for each axis by parameter No. 1421.
For detailed information, refer to the appropriate manual of the machine
tool builder.
5.2
RAPID TRAVERSE
Format
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *