FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
5. FEED FUNCTIONS
B–62764EN/01
90
Exact stop G09 IP_ ;
Exact stop mode G61 ;
Cutting mode G64 ;
Tapping mode G63 ;
Automatic corner override G62 ;
IP
The inter–block paths followed by the tool in the exact stop mode, cutting
mode, and tapping mode are different (Fig. 5.4.1 (a)).
0
Y
(1)
(2)
Position check
Tool path in the exact stop mode
Tool path in the cutting mode or
tapping mode
X
Fig. 5.4.1 (a) Example of Tool Paths from Block (1) to Block (2)
CAUTION
The cutting mode (G64 mode) is set at power–on or system
clear.
Format
5.4.1
Exact Stop (G09, G61)
Cutting Mode (G64)
Tapping Mode (G63)
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *