FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
5. FEED FUNCTIONS
101
Parameters related to automatic corner deceleration in look–ahead
control mode are shown below.
Parameter description Normal mode
Look–ahead
control mode
Switching the methods for automatic corner
deceleration
No.1602#4 No.1602#4
Allowable feedrate difference (for all axis) in
automatic corner deceleration based on the
feedrate difference
No.1780 No.1780
Allowable feedrate difference (for each
axis) in automatic corner deceleration
based on the feedrate difference
No.1783 No.1783
This function is not effective for feed–per–rotation commands,
address–F–with–one–digit commands, rigid tapping, and a single block.
D Look–ahead control
Limitations

Leave a Reply

Your email address will not be published. Required fields are marked *