FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

B–62764EN/01
SAFETY PRECAUTIONS
s–11
WARNING
3.
Fuse replacement
For some units, the chapter covering daily maintenance in the operators manual or programming
manual describes the fuse replacement procedure.
Before replacing a blown fuse, however, it is necessary to locate and remove the cause of the
blown fuse.
For this reason, only those personnel who have received approved safety and maintenance
training may perform this work.
When replacing a fuse with the cabinet open, be careful not to touch the high–voltage circuits
(marked
and fitted with an insulating cover).
Touching an uncovered high–voltage circuit presents an extremely dangerous electric shock
hazard.

Leave a Reply

Your email address will not be published. Required fields are marked *