FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
8. COORDINATE SYSTEM
115
With the G10 command, each workpiece coordinate system can be
changed separately.
By specifying G92IP_;, a workpiece coordinate system (selected with a
code from G54 to G59) is shifted to set a new workpiece coordinate
system so that the current tool position matches the specified coordinates
(IP_).
Then, the amount of coordinate system shift is added to all the workpiece
zero point offset values. This means that all the workpiece coordinate
systems are shifted by the same amount.
WARNING
When a coordinate system is set with G92 after an external
workpiece zero point offset value is set, the coordinate
system is not affected by the external workpiece zero point
offset value. When G92X100.0Z80.0; is specified, for
example, the coordinate system having its current tool
reference position at X = 100.0 and Z = 80.0 is set.
Explanations
D Changing by G10
D Changing by G92

Leave a Reply

Your email address will not be published. Required fields are marked *