FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
10. SPINDLE SPEED FUNCTION
(S FUNCTION)
131
10
SPINDLE SPEED FUNCTION (S FUNCTION)
The spindle speed can be controlled by specifying a value following
address S.
This chapter contains the following topics.
10.1 SPECIFYING THE SPINDLE SPEED WITH A CODE
10.2 SPECIFYING THE SPINDLE SPEED VALUE DIRECTLY
(S5–DIGIT COMMAND)
10.3 CONSTANT SURFACE SPEED CONTROL (G96, G97)
10.4 SPINDLE SPEED FLUCTUATION DETECTION FUNCTION
(G25, G26)

Leave a Reply

Your email address will not be published. Required fields are marked *