FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
11. TOOL FUNCTION
(T FUNCTION)
143
In a program, tool life management data can be registered in the CNC unit,
and registered tool life management data can be changed or deleted.
A different program format is used for each of the four types of operations
described below.
After all registered tool life management data is deleted, programmed tool
life management data is registered.
Programmed tool life management data for a group can be added or
changed.
Programmed tool life management data for a group can be deleted.
Count types (time or frequency can be registered for individual groups.
Whether tool life is to be indicated by time (minutes) or by frequency, it
is set by a parameter LTM (No. 6800 #2) .
Maximum value of tool life is as follows.
In case of minute:4300(minutes)
In case of frequency :9999(times)
11.2.2
Register, Change and
Delete of Tool Life
Management Data

D Register with deleting
all groups
D Addition and change of
tool life management
data
D Deletion of tool life
management data
D Register of tool life count
type
D Life value

Leave a Reply

Your email address will not be published. Required fields are marked *