FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
11. TOOL FUNCTION
(T FUNCTION)
B–62764EN/01
146
The following command is used for tool life management:
Toooo; Specifies a tool group number.
The tool life management function selects, from a specified group, a
tool whose life has not expired, and outputs its T code. In oooo,
specify a number calculated by adding the tool life management cancel
number specified in parameter6810 to a group number. For example,
to set tool group 1 when the tool life management cancel number is
100, specify T101;.
NOTE
When oooo is less than a tool life management cancel
number, the T code is treated as an ordinary T code.
M06; Terminates life management for the previously used tools,
and begins counting the life of the new tools selected with
the T code. A different code can be used by setting parameter
6811.
WARNING
When an option for speciofying multiple M codes is
selected, specify this code by itself or as the first M code.
H99; Selects the H code of tool life management data for the tool
currently being used.
H00; Cancels tool length offset
D99; Selects the D code of tool life management data for the tool
currently being used.
D00; Cancels cutter compensation
WARNING
H99 or D99 must be specified after the M06 command.
When a code other than H99 or D99 is specified after the
M06 command, the H code and D code of tool life
management data are not selected.
11.2.3
Tool Life Management
Command in a
Machining Program

D Command

Leave a Reply

Your email address will not be published. Required fields are marked *