FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
13. PROGRAM CONFIGURATION
B–62764EN/01
170
The 8–digit program number function enables specification of program
numbers with eight digits following address O (O00000001 to
O99999999).
Editing of subprograms O00008000 to O00008999, O00009000 to
O00009999, O80000000 to O89999999, and O90000000 to O99999999
can be disabled.
Parameter Program numbers for which editing is disabled
NE8(No.3202#0) O00008000 to O00008999
NE9(No.3202#4) O00009000 to O00009999
PRG8E(No.3204#3) O80000000 to O89999999
PRG9E(No.3204#4) O90000000 to O99999999
NOTE
When a wrong password has been specified for the
password function (see III–9.9), the settings of NE9 (bit 3 of
parameter No. 3202) and PRG9E (bit 4 of parameter No.
3204) cannot be changed.
For program punch by specifying a range, files are named as follows:
When punching by specifying O00000001 and O00123456:
“O00000001–G”
When punching by specifying O12345678 and O45678900:
“O12345678–G”
When 2–path control is being applied, the file name for the first path is
suffixed with “–1” and that for the second path is suffixed with “–2.”
Special subprogram numbers can be changed by using bit 5 (SPPR) of
parameter No. 3204.
1) Macro call using G code
Parameter used to
specify G code
Program number
specify
G
code
When SPPR = 0 When SPPR = 1
No.6050
No.6051
No.6052
No.6053
No.6054
No.6055
No.6056
No.6057
No.6058
No.6059
O00009010
O00009011
O00009012
O00009013
O00009014
O00009015
O00009016
O00009017
O00009018
O00009019
O90009010
O90009011
O90009012
O90009013
O90009014
O90009015
O90009016
O90009017
O90009018
O90009019
13.4
8–DIGIT PROGRAM
NUMBER
Explanations
D Disabling editing of
programs
D File name
D Special programs

Leave a Reply

Your email address will not be published. Required fields are marked *