FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
14. FUNCTIONS TO SIMPLIFY
PROGRAMMING
173
14
FUNCTIONS TO SIMPLIFY PROGRAMMING
This chapter explains the following items:
14.1 CANNED CYCLE
14.2 RIGID TAPPING
14.3 CANNED GRINDING CYCLE (FOR GRINDING MACHINE)
14.4 GRINDING WHEEL WEAR COMPENSATION BY
CONTINUOUS DRESSING (FOR GRINDING MACHINE)
14.5 AUTOMATIC GRINDING WHEEL DIAMETER
COMPENSATION AFTER DRESSING
14.6 IN–FEED GRINDING ALONG THE Y AND Z AXES AT THE END
OF TABLE SWING (FOR GRINDING MACHINE)
14.7 OPTIONAL ANGLE CHAMFERING AND CORNER ROUNDING
14.8 EXTERNAL MOTION FUNCTION
14.9 FIGURE COPY (G72.1, G72.2)
14.10 THREE–DIMENSIONAL COORDINATE CONVERSION
(G68, G69)
14.11 INDEX TABLE INDEXING FUNCTION
General

Leave a Reply

Your email address will not be published. Required fields are marked *