FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
14. FUNCTIONS TO SIMPLIFY
PROGRAMMING
B–62764EN/01
206
G80 cancels canned cycles.
G80 ;
All canned cycles are canceled to perform normal operation. Point R and
point Z are cleared. This means that R = 0 and Z = 0 in incremental mode.
Other drilling data is also canceled (cleared).
M3 S100 ; Cause the spindle to start rotating.
G90 G99 G88 X300. Y–250. Z–150. R–120. F120. ;
Position, drill hole 1, then return to point R.
Y–550. ; Position, drill hole 2, then return to point R.
Y–750. ; Position, drill hole 3, then return to point R.
X1000. ; Position, drill hole 4, then return to point R.
Y–550. ; Position, drill hole 5, then return to point R.
G98 Y–750. ; Position, drill hole 6, then return to the initial level.
G80 G28 G91 X0 Y0 Z0 ;
Return to the reference position return,
canned cycle cancel
M5 ; Cause the spindle to stop rotating.
14.1.14
Canned Cycle Cancel
(G80)
Format
Explanations
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *