FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
14. FUNCTIONS TO SIMPLIFY
PROGRAMMING
B–62764EN/01
218
Do not specify a group 01 G code (G00 to G03) and G73 in the same block.
If they are specified together, G73 is canceled.
In the canned cycle mode, tool offsets are ignored.
The rigid tapping canned cycle is canceled. For how to cancel this cycle,
see II–14.1.14.
D Cancel
D Tool offset
14.2.4
Canned Cycle Cancel
(G80)

Leave a Reply

Your email address will not be published. Required fields are marked *