FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
B–62764EN/01
14. FUNCTIONS TO SIMPLIFY
PROGRAMMING
227
X, (Z), I, J, and K must all be specified in incremental mode.
I, J, X, and Z in canned cycles are modal data common to G75, G77, G78,
and G79. They remain valid until new data is specified. They are cleared
when a group 00 G code other than G04 or a group 01 G code other than
G75, G77, G78, and G79 is specified.
Restrictions
D X, I, J, K
D Clear

Leave a Reply

Your email address will not be published. Required fields are marked *