FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

GENERAL
1. GENERAL
B–62764EN/01
4
This manual uses the following symbols:
P
I
_
Indicates a combination of axes such as
X__ Y__ Z (used in PROGRAMMING.).
Indicates the end of a block. It actually corre-
sponds to the ISO code LF or EIA code CR.
The table below lists manuals related to MODEL C of Series 16, Series
18, Series 160 and Series 180. In the table, this manual is marked with
an asterisk (*).
Table 1 Related Manuals
Manual name
Specification
number
DESCRIPTIONS B–62752EN
CONNECTION MANUAL (Hardware) B–62753EN
CONNECTION MANUAL (Function) B–62753EN–1
OPERATOR’S MANUAL for Lathe B–62754EN
OPERATOR’S MANUAL for Machining Center B–62764EN
*
MAINTENANCE MANUAL B–62755
PARAMETER MANUAL B–62760EN
PROGRAMMING MANUAL (Macro Compiler / Macro Executer) B–61803E–1
FAPT MACRO COMPILER PROGRAMMING MANUAL B–66102E
FANUC Super CAP T/Super CAP II T OPERATOR’S MANUAL B–62444E–1
FANUC Super CAP M/Super CAP II M OPERATOR’S MANUAL B–62154E
FANUC Super CAP M PROGRAMMING MANUAL B–62153E
CONVERSATIONAL AUTOMATIC PROGRAMMING FUNCTION I
for Lathe OPERATOR’S MANUAL
B–61804E–1
CONVERSATIONAL AUTOMATIC PROGRAMMING FUNCTION II
for Lathe OPERATOR’S MANUAL
B–61804E–2
CONVERSATIONAL AUTOMATIC PROGRAMMING FUNCTION
for MACHINING CENTER OPERATOR’S MANUAL
B–61874E–1
Special symbols
Related manuals

Leave a Reply

Your email address will not be published. Required fields are marked *