FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62764EN/01
252
15
COMPENSA TION FUNCTION
This chapter describes the following compensation functions:
15.1 TOOL LENGTH OFFSET (G43, G44, G49)
15.2 AUTOMATIC TOOL LENGTH MEASUREMENT (G37)
15.3 TOOL OFFSET (G45–G48)
15.4 CUTTER COMPENSATION B (G39–G42)
15.5 CUTTER COMPENSATION C (G40–G42)
15.6 DETAILS OF CUTTER COMPENSATION C
15.7 THREE–DIMENSIONAL TOOL COMPENSATION (G40, G41)
15.8 TOOL COMPENSATION VALUES, NUMBER OF
COMPENSATION VALUES, AND ENTERING VALUES FROM
THE PROGRAM (G10)
15.9 SCALING (G50, G51)
15.10 COORDINATE SYSTEM ROTATION (G68, G69)
15.11 NORMAL DIRECTION CONTROL
(G40.1, G41.1, G42.1 OR G150, G151, G152)
15.12 PROGRAMMABLE MIRROR IMAGE (G50.1, G51.1)
15.13 GRINDING WHEEL WEAR COMPENSATION
General

Leave a Reply

Your email address will not be published. Required fields are marked *