FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

GENERAL
B–62764EN/01
1. GENERAL
5
When machining the part using the CNC machine tool, first prepare the
program, then operate the CNC machine by using the program.
1) First, prepare the program from a part drawing to operate the CNC
machine tool.
How to prepare the program is described in the Chapter II.
PROGRAMMING.
2) The program is to be read into the CNC system. Then, mount the
workpieces and tools on the machine, and operate the tools according
to the programming. Finally, execute the machining actually.
How to operate the CNC system is described in the Chapter III.
OPERATION.
Part
drawing
Part
programming
CHAPTER II PROGRAMMING CHAPTER III OPERATION
CNC
MACHINE TOOL
Before the actual programming, make the machining plan for how to
machine the part.
Machining plan
1. Determination of workpieces machining range
2. Method of mounting workpieces on the machine tool
3. Machining sequence in every machining process
4. Machining tools and machining
Decide the machining method in every machining process.
Machinin
g
process
1 2 3
Machining
rocess
Machining procedure
Feed cutting Side cutting
Hole
machining
1. Machining method
: Rough
Semi
Finish
2. Machining tools
3. Machining conditions
: Feedrate
Cutting depth
4. Tool path
1.1
GENERAL FLOW
OF OPERATION OF
CNC MACHINE
TOOL

Leave a Reply

Your email address will not be published. Required fields are marked *