FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62764EN/01
260
In tool length offset mode
Type EVO (bit 6 of pa-
rameter No. 5001)
Restoration block
A/B
1 Block containing a G43/G44
block
A/B
0 Block containing an H command
and G43/44 command
C
Ignored Block containing a
G43P_H_/G44P_H_ command
WARNING
When tool length offset is applied to multiple axes, all axes
for which G53, G28, G30, and G30.1 are specified are
subject to cancellation. However, restoration is performed
only for that axis to which tool length offset was applied last;
restoration is not performed for any other axes.
NOTE
In a block containing G40, G41, or G42, the tool length
offset vector is not restored.

Leave a Reply

Your email address will not be published. Required fields are marked *